All necessary information are available here.
And the bits that I care about:
Download and Install
Click the link, or cut and paste the whole command line below to download the driver.
$ wget -O foo2zjs.tar.gz http://foo2zjs.rkkda.com/foo2zjs.tar.gz
Now unpack it:
$ tar zxf foo2zjs.tar.gz
$ cd foo2zjs
Now compile and install it. The INSTALL file contains more detailed instructions; please read it now.
Install driver, foomatic XML files, and extra files:
$ su OR $ sudo make install
# make install
(Optional) If you use CUPS, restart the spooler:
# make cups OR $ sudo make cups
Now create printer entries for your spooler.
Once the above is done simply go to https://Your_cups_server:631/ and add the printer:
and if everything went OK the driver will be visible somewhere near the bottom of the list as listed above.
Stage 1 – Physically install the HDDs
Stage 2 – Expand the Array
- Start HP Array Configuration Utility:
- Select Array that you want to expand and click the Expand Array Button:
Once you press Save the array will start the transformation process.
The speed will depend on amount of data on the existing array and size of the array.
In this example the existing drive has 135GB size with 15GB free:
The expansion rate was approx 9GB per hour
While the process is running you will see these alerts:
You can further increase the speed of the transformation by changing the controller settings (set transformation priority to High):
Changing the priority to High might have an impact on server performance (read/write operations)
Stage 3 – Extend Logical Drive
Select the drive that you want to extend and click the Extend Logical Drive:
accept the default and click save
Read the warning and Click OK
(it basically says that if you are running windows 2000 you might have problems, otherwise you are fine)
That process usually takes just a few seconds/minutes (press refresh button to confirm it’s finished)
To verify open Windows Computer Management/Disk Management:
Stage 4 – Extend OS volume
From command prompt issue commands as listed below:
Verify that all went OK:
when connected via telnet to the switch execute:
show mac-address command: